![]() ![]() Wireless is configured as access point and bridged with all available Ethernet ports. IP address on WAN port is acquired automatically. This configuration type is applied to routers that has both LTE and wireless interfaces. In this type of configurations router is configured as wireless client device. ![]() This page was last edited on 27 Juneat There are several different configurations depending on board type. The reason might be, that configuration script is executed before RouterOS is booted successfully.įlashfig configuration maximum file size is up to bytes, otherwise program will return error as above. If all procedures went successfully, but RouterOS configuration from. Flashfig diagram shows the procedure of Flashfig. Therefore using Flashfig is normally a one time process. To permanently overwrite factory default configuration, use Netinstall process not FlashFig. ![]() To use Flashfig a second time on the same router, you need to enable flash-boot in Bootloader settings. Running Netinstall in Flashfig mode only runs on a Windows computer and Netinstall is available from the downloads page.Īfter Flashfig is used once on a brand new RouterBOARD, it is disabled on further boots to avoid unwanted reconfiguration at a later time. It can be used by MikroTik distributors, ISPs or any other companies who need to apply RouterOS configuration to many routers in the shortest possible time. Flashfig is an application for mass router configuration. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |